Tail Tidy Help!

[mikeharibo]

hey i know this is probably been answered but I havent been able to find where! Just ordered a tail tidy for my SV and in the description it says it is a direct replacement for my old one. But I cannot see where it is held on to the undertray. I have looked but maybe Im being a typical youngster and giving up after 5 mins :confused: Any help would be greatly appreciated.

[hovis]

what make is it?

i know the curvy you have to cut the old one off, not sure about a pointy

[mikeharibo]

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&rd=1&item=140193132600&ssPageName=STRK:MEWN:IT&ih=004

is the link

[hovis]

This tail tidy bolts in place using the same mounting points as the original plastic fender - you don`t have to hack or drill !


does that help?

[mikeharibo]

Yeah thats what I cant see? Maybe Im just been thick? Has anyone got a pic of where it bolts in?

[coggers28]

If you are a beginner than the Tail tidy on pointy can be a pain in the **** to fit.

Have a look at this web site:
http://www.hamicad.co.uk/SV_Fender/SV%201000%20650%20fender%20instructions%20new.pdf

Hope that helps:D

[Bear]

Basically you need to remove all the rear plastics, and then remove the current snow-shovel to fit the tail tidy. It's a reasonably easy job, but it can take a while. Give yourself an hour and a half to two hours and lots of tea break time and it'll be fine. It was the first thing I fit to the bike and it worked out fine.

[mikeharibo]

So need to remove the whole tail plastics then? What kind of screws hold the plastics on?

[coggers28]

Step by Step instructions . Have a look at this web site::rolleyes:

http://www.hamicad.co.uk/SV_Fender/S...ions%20new.pdf

[hovis]

What kind of screws hold the plastics on?

dunno.............. go and have a look;)


HTH