TRE Mod Problem

[df1uk]

Hi, I have a SV650s K6 (2006) which I fitted a TRE mod to, after fitting the bike starts fine but the red warning light stays on where the temp is displayed it alternates between temp and FI. I have followed the instructions on how to make, using 15ohm resistor and fitting between the pink and black wires after removing from the plug, I left only the blue wire in and then reconnected the plug. I was using a 15 ohm 3w resistor (is this OK?). Has anyone else seen this if so how I can I fix.

Dave

[LEXINGTONONE]

Hi
dont know if this is anything to do with your problem but you say you fitted a 15 ohm resistor, well I fitted a 15kohm resistor as in diy tre instructions and have had no problems, it maybe that you need the 15k and not the 15 ohm resistor, ps 3 watt should be ok mine is 2.5 watt rated.

[df1uk]

Sorry Stand corrected it is a 15k

[df1uk]

Think it might be to do with 15ohm as opposed to 15k, have now got right resistor will fit tonight and report back.

Dave