View Full Version : Washing Woes
svdemon
19-08-08, 09:50 PM
The past few times i've washed my bike it has run like a bag of spanners for a good while afterwards. I must be getting water somewhere i shouldn't be but where to check?
I've sealed the plugs off with silicon grease but the rest of the HT system is untouched. Where else should i be sealing?
sam anon
21-08-08, 12:48 PM
Are you plugging your end can?
Luckypants
21-08-08, 12:51 PM
Do you use a power washer? That can force water into places it should never go.
svdemon
21-08-08, 02:45 PM
No power washer but i gave the engine block a good clean with bar keepers friend and its not been right since. I'll check the dealer mode and see if anything flags up.
svdemon
21-08-08, 07:01 PM
Its a connector which you can use to find out error codes on the bike, you can see it here
http://forums.sv650.org/showthread.php?t=55459&highlight=throttle+position+sensor
vBulletin® , Copyright ©2000-2025, Jelsoft Enterprises Ltd.