hi level link pipe question

[t18con.]

i'm about to buy a hi level link pipe, its for a scorpion can, 51mm inlet, so the starting place for my search was scorpion, but on looking at their site the high level can appears to follow a different line to the rear bodywork on the bike.
is there a high level link pipe that allows the can to follow the original lines of the bike or is there enough flexibility at the joints for adjustment of angle?

[dizzyblonde]

dunno where mine came from, think it were a custom made job, as the previous owner as i recall had it made to fit, also its a chopped down scorpion
http://i2.photobucket.com/albums/y8/Dan_SV/SVSale028.jpg

http://i2.photobucket.com/albums/y8/Dan_SV/SVSale047.jpg
http://i2.photobucket.com/albums/y8/Dan_SV/SVSale046.jpg

[Dangerous Dave]

http://www.scorpion-exhausts.com/uploads/vehicles/bikes/side-carbon%2072dpi.jpg

It looks far better than the Pointy version though....

http://www.scorpion-exhausts.com/uploads/vehicles/bikes/highlevel%20angle%2072dpi.jpg

Before you tighten all the clamps you can twist/swivel the link pipe around a bit to see which angle looks best.

[t18con.]

i know which angle looks best, the angle on the curvy looks best, pity its on the "less pretty" version of the sv! lol

[Dangerous Dave]

pity its on the "less pretty" version of the sv!
They should ban members like you!!! :p

Scorpion knew the Pointy SV was ugly so they wasted no time in make a half decent looking exhaust for it, they knew the Pointy will always be ugly no matter what.

[husky03]

Banditmania do a nice hi level link for the curvy

[dizzyblonde]

Banditmania do a nice hi level link for the curvy

if you can get em to send you it!

[Dangerous Dave]

if you can get em to send you it!
+ 1,000,000

[t18con.]

right, that scorpion themselves rules out, they will NOT sell a link pipe separately from a can.

[dizzyblonde]

Zorstec can do you a custom link pipe, but I don't know where you live...They did my link pipe on Suzy