Fitting an exhaust to a K7

[shonadoll]

apparently it has a lambda sensory thing I have to avoid? I ordered a Beowulf exhaust, and it looks pretty logical to put on, but it also looks like I can unbolt the original exhaust rather than cut through it?

I'm just worried in case I chop too much off - apparently the K7 is different from other models in this respect, does anyone know?:scratch:

[Dangerous Dave]

Nah... you have to cut it still as far as I am aware.

[shonadoll]

Ok, thanks.

[shonadoll]

Does anyone know about the lambda sensor thing?

[Dangerous Dave]

Keep it in.

[gazza]

The end can has to be cut off. I cut mine about 50mm towards the endcan from the weld line . The lambda sensor is left in position. It aint a hard job, took me about 20 mins start to finish. Just line up the new can and link pipe to get the approx point that the pipe needs to be cut.

[shonadoll]

The end can has to be cut off. I cut mine about 50mm towards the endcan from the weld line . The lambda sensor is left in position. It aint a hard job, took me about 20 mins start to finish. Just line up the new can and link pipe to get the approx point that the pipe needs to be cut.


Brilliant, thankyou so much, needed that detailed stuff.

[shonadoll]

Keep it in.
:-DThanks!