carty
19-09-08, 11:13 AM
Hi all,
I've received my new RH clip-on in the post today so I can replace the one sheared off in my 'incident' last Sunday (came off at Rockingham for those who haven't seen it in the review thread!)
All the bits attached to my old one seem ok so I'm just swapping them over, so I have to remove the throttle, the starter / kill switch attachment and the brake set-up from my old one and put it on the new one.
Can anyone who's done this advise me on the best order to do things please? Should I put the new clip-on on the fork then put things on or should I attach things before putting it on the fork?
What's the easiest way to remove the throttle? (It might just pull off but I haven't tried yet!)
Cheers,
Matt
I've received my new RH clip-on in the post today so I can replace the one sheared off in my 'incident' last Sunday (came off at Rockingham for those who haven't seen it in the review thread!)
All the bits attached to my old one seem ok so I'm just swapping them over, so I have to remove the throttle, the starter / kill switch attachment and the brake set-up from my old one and put it on the new one.
Can anyone who's done this advise me on the best order to do things please? Should I put the new clip-on on the fork then put things on or should I attach things before putting it on the fork?
What's the easiest way to remove the throttle? (It might just pull off but I haven't tried yet!)
Cheers,
Matt