Paging anyone with a Yamaha 250 or 350LC

[Lozzo]

I need to know what the length of the forks is when fully extended please, also how far apart the forks are mounted. An overall measurement from outside of one leg to outside of the other would suffice as the diameters are the same on the project I'm planning.

Thanks

[RingDing]

Not sure if I'll get a chance to check tonight but I can measure mine up. Might have to wait until Fri evening is all...

[Lozzo]

Not sure if I'll get a chance to check tonight but I can measure mine up. Might have to wait until Fri evening is all...


That'll be fine, there's no immediate rush.

Thanks

[RingDing]

Got home earlier than expected.

Top of fork to center of axle = 738mm

Outer edge of one fork to the other = 210mm

Accuracy of approximately 2mm I'd say.

Couldn't get a center to center measurement on the forks as the bar mount gets in the way. If I can find the spare yoke in the shed at the weekend I can measure that for you.

Good luck with the project, looks interesting.

[Lozzo]

Thanks so much, that's helped greatly.

[RingDing]

No worries.