Log in

View Full Version : Curvy bits and bobs needed

Jay12329
29-03-09, 06:08 PM
I'm after a few bits for my '99 650 project thought i'd try here to help out a orger rather than the shops... So if you've got any spares sitting in the garage gathering dust.

So I'm after...
Front brake lever
Clutch lever
Throttle cables
Clutch cable
Choke cable
RHS switch gear
Brake pads - Front and rear
Chain and sprockets
Clutch plates

And on the off chance...
Right and left engine cover gaskets

ta
J
TheShadow
29-03-09, 06:35 PM
Thats some list , sadly i cant help but i hope someone comes along with what you need!.

I'm after a few bits for my '99 650 project thought i'd try here to help out a orger rather than the shops... So if you've got any spares sitting in the garage gathering dust.

So I'm after...
Front brake lever
Clutch lever
Throttle cables
Clutch cable
Choke cable
RHS switch gear
Brake pads - Front and rear
Chain and sprockets
Clutch plates

And on the off chance...
Right and left engine cover gaskets

ta
J
Dave20046
29-03-09, 07:32 PM
Other than the switchgear and levers I'd be looking at buying new. ebay, local shop, online parts sites - they're all servicing parts other than the plates maybe. I got a complete set of front pads for £38 posted off ebay recently (ebc-hh).
Dave20046
29-03-09, 07:33 PM
I have a switchgear by the way took it off because the little nubbin was broken and ordered one from someone off here, got the new one and it had the same issue :rolleyes:
But once fitted turns out it was fine anyway!
Jay12329
30-03-09, 08:30 PM
Other than the switchgear and levers I'd be looking at buying new. ebay, local shop, online parts sites - they're all servicing parts other than the plates maybe. I got a complete set of front pads for £38 posted off ebay recently (ebc-hh).

Have you still got the seller info?
ta
J
maviczap
30-03-09, 08:34 PM
Got a dirty set of chain and sprockets. They've done about 7800 miles.

But not rusty, just filthy.

Chain is unbroken as I removed the swingarm as part of my winter refurb.

Could be pricey to post mind
Dave20046
30-03-09, 08:34 PM
egypt22? Might have been a one off tohugh he wasn;t a power seller.
yorkie_chris
31-03-09, 10:59 AM
I have a choke cable (reasonable nick) for an S model. (too short for proper handlebars). And a couple of complete clutch packs. I've not tested the clutches, but will check for thickness and warp.
Which bits you need?