front brake system

[DANINPLYMOUTH]

The sv is now gone :(, didnt get round to getting half the bits of it i should have. anyways i have left a set of 4pot tokiko calipers, with the sv racing mounting plates so they bolt straight on and they are fitted with braided lines looking for £120 and theyll be dropped to your door

I honestly cant praise this set up enough bloody s##t myself when i had the stock set up on to take my bike back to the shop

Thanks all

[Moojuicepez]

pictures?

[Speedy]

I might be interested in those too Dan, Any photos?

[DANINPLYMOUTH]

ta da
the mechanic who fitted them give them a good clean and new pads and i would gues iv done about 400miles on them, im not just saying as im selling them but to me this was far and away the best mod made to the sv

[DANINPLYMOUTH]

Bump
also got the stock can and tail un-tidy if anybody needs them

[2hys]

wot about the handgards, rodders!

[DANINPLYMOUTH]

Didnt have time to end up getting them off the bike
you like the new wheels?

[Lucas]

will brakes fit curvy?

ps. guess the carbon can is no more?

cheers

[2hys]

i will have to find some i think!

yeah, i do like your new bike.
chells shown some intrest in getting her own bike/licence so watch this space!

[DANINPLYMOUTH]

Hi Lucas, sorry in the end i couldn't get the carbon can off.
Honestly not to sure about fitting the curvy, will have a search through here and see what i can find

Thanks

[Lucas]

no worries and thanks for the effort :smt023

[yorkie_chris]

will brakes fit curvy?

ps. guess the carbon can is no more?

cheers

As far as I can see they should fit the curvy fine.

However I would get the superior ones from twin works factory rather than the SVRP ones.

[DANINPLYMOUTH]

Thanks for that YC was just about to post a thread and ask if they would fit. Cause i really didn't have a clue but from my memory they only sell 1 set of adapters to fit all years so sort of guessed they were the same

[yorkie_chris]

Oh they are also a good upgrade for DL650s. Might even fit gladioli too.

[DANINPLYMOUTH]

bumpty bump

[xXBADGERXx]

I have a passing interest in these Dan , small worry I have is that I am running an ABM comfot kit and my Braided lines are already tight from my lever to the Banjo`s . Do these calipers fit a lot further around and down on the plates ?

[DANINPLYMOUTH]

give me 2 ticks il go measure the lines

[DANINPLYMOUTH]

there aprox 30" from bango bolt to bolt.
is yours an s or n?
these were fitted to my n which i think have slightly higher bars anyway but please anyone correct me if i am wrong

[xXBADGERXx]

I have an S but with an ABM comfort kit on it with Renthal bars , so fairly close to a Naked setup , bit late for me to measure up now so will finish work tomorrow afternoon and get my tape measure out :)

[chakraist]

I would recommend 4 pot brakes too- they're amazing and stoppie on a finger.

[davwas]

Hi

I'm very interested.
Is the master cylinder included with the system?

Cheers
Dave

[DANINPLYMOUTH]

Hi, sorry the master cylinder is not included.
Mine was used with the standard sv master cylinder and still the difference was dramatic, couldn't beleive how poor the brakes were when i swapped back to the original calipers. And its not like my standard calipers were shot either as i had the bike from new

Thanks

[davwas]

Hi

PM sent

[xXBADGERXx]

If you read the thread you can see I was in negotiations with checking this out for a possible buy , you don`t just barge in and swipe it away from under somebody else`s nose .

[davwas]

Sorry pal

I didn't see "negotiation".

[xXBADGERXx]

What we tend to do on this site is show interest and if we decide to pass on it then the next person in line can have a stab at it , I`d said I was gonna measure my lines when it was daylight to see if they would fit and then if all was good , buy these , obviously you are here 2 seconds and get highest priority , thanks a bloody lot .

[DANINPLYMOUTH]

SOLD

Sorry think there was bit of a misunderstanding on this