Exhaust can fitting question.

[Curvy-smerv]

Hi everyone,

I've been offered a Blueflame Evo end can but it doesn't come with a link pipe. Will I need one to fit it straight onto my '99 Curvey or will I have to cut the pipe on my current exhaust for it to fit?

All advice gratefully recieved!

Thanks

[dkid]

Think you'll need to cut the original exhaust off around 50mm up from the weld that joins the 2into1 and the pipe that goes into your end can. Then you'll need a curvy link pipe to go between the new can and the cut.

There's quite a few 'how to' vids on youtube.

I had one of those blueflame evos. Sound great!!!

[davepreston]

standard sv zausts always need cut and a link pipe
just check the bore of the zaust matchs your pipes

[dkid]

http://m.youtube.com/index?desktop_uri=%2F&gl=US#/watch?v=-jyRRCYSZzE

This should help



Sent from my iPhone using Tapatalk

[Curvy-smerv]

Hi guys

Thanks for your help. They are both 52 in diameter so that should be fine. May need some suggestions for a decent reasonably priced welder / fabricator type personage in the Folkestone-ish area shortly!

I'll check out the vids! Thanks!

[AZZ3R]

Any standard Angle Grinder will cut it but you will need a metal cutting disk (ovbisouly), I'd get 2 depending on the size of your grinder will take, should take about 5-10mins to cut through.

Then it's all pretty straight forward from then, the link pipe just simply rotate I've got a 'how to' from Delkevic when I did mine your welcome to have it if you like? will be the same as fitting any other slip on to a curvy.

[Curvy-smerv]

Hi all

Thanks for all your replies, its much appreciated. Just got to wait for arrival of said Evo and get a link pipe now.

AZZ3R...

Thanks for that. I'll drop you a PM later!

[Curvy-smerv]

Someone at work has just advised me to get the carbs balanced when the Evo goes on..any thoughts?

[daveyrach]

Shouldn't need to if its just the end can your replacing.

[Curvy-smerv]

Hi there,

Thanks for the reply. I'm actually hoping to put a raised link pipe on it....

[daveyrach]

Still shouldn't make a difference