Fitting carbtune hoses to the throttle body

[muzikill]

Gawd what a fiddly nightmare btw!

[yorkie_chris]

Indeed.

Try it on a hot engine.

[TSM]

so easy on a sv

[muzikill]

Yer kidding. Theres no way my fingers were getting in to take off the rubber stoppers easily.

[TSM]

Yer kidding. Theres no way my fingers were getting in to take off the rubber stoppers easily.

rear cylinder you just take pull off 'T' that supplies vac the fuel tank tap, easy
front cylinder, you put yr hand up from the bottom behind the rad (poss unbolt rad at bottom and pull forwards) while layed down, easy, to make that easier in the future put a small bit of rubber hose on there and block it afterwards leaving it hanging down.

[Sid Squid]

That's carbs - try it on an FI system. OP says 'throttle body'.

[TSM]

That's carbs - try it on an FI system. OP says 'throttle body'.

ahh yeh missed that

[Sid Squid]

Thought so. ;)

[muzikill]

Now its a toss up between not doing the extended hose mod out of the bodies for future balance or not. If i do this once a year then taking off all of those bits would be something i would do anyway to clean it up.