Pull clutch and bike cuts out (2011 model)

[Galviniser]

Hey again,

Just general riding about and I noticed more often than not when I pull my clutch the revvs drop to 200rpm, that's very low and never seen it happen like this before, then I put it in gear, but just now on my way home I pulled the clutch and it just cut clean out :/ I don't know if installing these new levers have anything to do with it because its only just started happening after I installed them ?

Any clues?

Cheers

Chris


Sent from my iPad using Tapatalk

[maviczap]

Refit the original levers and see if this still happens.

[Galviniser]

Literally just done that now, I noticed there's a switch on the clutch I presume that is for pulling the clutch to start it, to tell it the clutch has been pulled, on the after market levers there is nothing to push the switch back in, I wonder if it has something to do with that, I'll find out on my ride home today

Sent from my XT890 using Tapatalk 2

[Galviniser]

Put the original clutch lever back on, perfect, so gona make something to trigger the switch on the aftermarket levers


Sent from my iPad using Tapatalk