DavieSV
08-07-15, 03:51 PM
Has any body any interest in a complete plug and play GSXR front end?
http://images.tapatalk-cdn.com/15/07/08/f397898dfcbff4fd19bf0c73f1a410b0.jpg
http://images.tapatalk-cdn.com/15/07/08/85dc463bae70ed966d06d0b1d4a626f0.jpg
Consists of:
Gsxr K7 forks, racetech 0.9 springs, re-valved by Yc,
Radial calipers,
SV1000 discs (could do with replacing),
Sv650 front wheel, disc spacers, custom spindle and nearly new 120/70 Pilot power,
Carbon fibre mud guard,
GSXR bottom yoke,
Custom billet top yoke, with nut,
TL clip ons,
GSXR Radial master cylinder,
Stainless steel bar ends with sliders,
Switches and grips,
Clutch lever,
Speedo mod (with cable to plug into the loom)
The whole lot to just bolt on and go, but for safety reasons, calipers could do with a clean/service and the discs are a bit rusty after being stood at work for a bit.
£800 collected.
I will also throw in a new fender extender (if I can find it).
I will also throw in, if wanted, the fuel filler surround and radiator end plates that are powder coated the same colour as the top yoke and wheel.
The Speedo mod is for an eight magnet drive, made from billet aluminium and bolted to the disc. I will supply a blank disc with no magnets if you only need four magnets.
http://images.tapatalk-cdn.com/15/07/08/d9fdc9523c7e7a95ab34d0eaef176a38.jpg
Thanks for looking.
John.
Sent from my C6903 using Tapatalk
http://images.tapatalk-cdn.com/15/07/08/f397898dfcbff4fd19bf0c73f1a410b0.jpg
http://images.tapatalk-cdn.com/15/07/08/85dc463bae70ed966d06d0b1d4a626f0.jpg
Consists of:
Gsxr K7 forks, racetech 0.9 springs, re-valved by Yc,
Radial calipers,
SV1000 discs (could do with replacing),
Sv650 front wheel, disc spacers, custom spindle and nearly new 120/70 Pilot power,
Carbon fibre mud guard,
GSXR bottom yoke,
Custom billet top yoke, with nut,
TL clip ons,
GSXR Radial master cylinder,
Stainless steel bar ends with sliders,
Switches and grips,
Clutch lever,
Speedo mod (with cable to plug into the loom)
The whole lot to just bolt on and go, but for safety reasons, calipers could do with a clean/service and the discs are a bit rusty after being stood at work for a bit.
£800 collected.
I will also throw in a new fender extender (if I can find it).
I will also throw in, if wanted, the fuel filler surround and radiator end plates that are powder coated the same colour as the top yoke and wheel.
The Speedo mod is for an eight magnet drive, made from billet aluminium and bolted to the disc. I will supply a blank disc with no magnets if you only need four magnets.
http://images.tapatalk-cdn.com/15/07/08/d9fdc9523c7e7a95ab34d0eaef176a38.jpg
Thanks for looking.
John.
Sent from my C6903 using Tapatalk