Loud tick noise and then stalling on tick over ??

[Lumpy]

Hi . Had a run out on Sunday bike was riding great but pulled up at lights and
It cut out ( never before ) . Started ok but revs dropping and a tick
Noise . It ticks and revs drop and then ok . I'm thinking could be plug leads
( new plugs in ) any thoughts
Cheersv

[Lumpy]

Sorry it's a 2000 curvey !

[Bibio]

carbs needing balanced

camchain tensioner stuck

tickover needing adjusted

low oil, if its been run on low oil then engine will likely be toast.

[Craig380]

How long ago did you fit the new plugs? Are they tightened up snug, or could one have worked loose a little? Are the plug caps fitted tightly?

[Lumpy]

The plug and leads are the rought I'll be lookin first . Bike runs
And pulls fine at higher revs
I'll take a look tonight . Ta

[SV650rules]

vacuum leak, did any pipes get disturbed when fitting new plugs ? sometimes old pipes are OK until they get moved and then they leak.

[Lumpy]

I'll check all tonight . The bike has only done
About 200 mile since strip down and cafe raced
One thing I do know the battery is a old one
?????

[Lumpy]

Had a look last night but didn't have a lot of time .
Bike fired and tick over was fine until it got hot
Then was cuttin out when tickin over .
More investigation needed

[Bibio]

turn the tickover up. should idle around 1400rpm.

[Lumpy]

I'll have a go! To me it sounds electrical
Something braking down . Like I said no problem when cold