JohnSheep
29-05-24, 06:12 PM
Hi Guys
I’m in the UK on an a2 license and want to be able to switch between full power and restricted(47hp).
I only want to be able to switch to lower power easily and discretely in case I ‘went to a track’. (I know most people will say just don’t do it but I want to).
I've had a few ideas on how I could do this:
Running 2 ECU's in parallel
I was thinking about installing both a restricted ECU and a normal ECU in the bike and then having both connected at the same time. I would then wire 2 switches to kill power to one of the ECUs so one is 'dead' and won't respond.
Dual map PowerCommander (piggyback)
I have reservations about trying this because a PowerCommander is £450 and I'm not actually sure this will work.
I could have a PC with a map switcher, run 1 map with normal AFR(air-fuel ratio) and 1 map where I half the AFR to massively reduce power.
The problem is I'm not sure a PowerCommander offers enough adjustment to half the AFR so this may not work.
Switch to disable the ignition
This is the most crude approach - if the bike were to be seized I could flick a switch so the ignition is just no longer connected so it won't start so it can't be dyno'd.
However, I dont think this would go down too well...
I’m in the UK on an a2 license and want to be able to switch between full power and restricted(47hp).
I only want to be able to switch to lower power easily and discretely in case I ‘went to a track’. (I know most people will say just don’t do it but I want to).
I've had a few ideas on how I could do this:
Running 2 ECU's in parallel
I was thinking about installing both a restricted ECU and a normal ECU in the bike and then having both connected at the same time. I would then wire 2 switches to kill power to one of the ECUs so one is 'dead' and won't respond.
Dual map PowerCommander (piggyback)
I have reservations about trying this because a PowerCommander is £450 and I'm not actually sure this will work.
I could have a PC with a map switcher, run 1 map with normal AFR(air-fuel ratio) and 1 map where I half the AFR to massively reduce power.
The problem is I'm not sure a PowerCommander offers enough adjustment to half the AFR so this may not work.
Switch to disable the ignition
This is the most crude approach - if the bike were to be seized I could flick a switch so the ignition is just no longer connected so it won't start so it can't be dyno'd.
However, I dont think this would go down too well...