PDA

View Full Version : Headlight High/Low /Wiring


Powergaard
04-10-04, 10:36 AM
I know i have posted this before, but I seem to have lost some posts in the weekend.

In your UK headlight, is the low beam on, as well, when you turn on the high beam, or does it turn it selves off automaticly?? what part determines the switch between the two settings ?(high/low)

And any idea on how thick the wiring is from the headlight bulps ??? i have seen the uk Suzuki manual and its not to clear on the subject ?

chazzyb
04-10-04, 11:04 AM
I know i have posted this before, but I seem to have lost some posts in the weekend.

Yes, and my response went too.

On my naked '99 model, only one filament is used at a time: either main beam or dip. The only time I get both is if I use the 'pass' switch. I don't know what on the faired bikes.

Philbo
04-10-04, 11:17 AM
If it's a 55watt bulb, you will need cable that can safely conduct 4.6 amps, (I=P/V). So a 0.75mm or 1.0mm cable would work for you.

Graham
05-10-04, 02:09 AM
what part determines the switch between the two settings ?(high/low)

:shock: Err, The High, Low beam switch :roll: