For curvy: Starter motor, carbs.

[northwind]

Just want a spare starter to get powdercoated... Any condition considered, since I can swap bits with mine.

Also, a set of carbs in good nick- doesn't matter if they've been messed with as long as they work and are in good condition. Again, looking for spares so I can mess with my original ones more :)

[TSM]

My old carbs are comming off my bike. The only problem with them is the mixture screw is stuck solid and the brass heads have been damaged, but in the correct place for a standard carb setup.

[northwind]

Think teh stuck mix screw would be a problem... How stuck is stuck? :)

[Mike1234]

Shouldn't be a problem - I've never messed with the mixture screw on any of my carbs. I think the ones on the Raptor still have the blanking covers in the holes.

[northwind]

Mine have needed tweaked a couple of times... IIRC 9and this might be rubbish) I'm on a hair over 2 3/4 turns on the front, and a hair under on the back.

Since this new set will be being rebuilt for a stage 3 setup, I'm definately not getting into that sort of work with a lack of adjustability. Whether or not I'll need it is another matter of course.

[TSM]

there is no head to the screw, they were stuck solid, you may possably get them out if you are good at that stuff & replace them for new one.

[dirtydog]

I've got a set of carbs, they have a dyno jet kit fitted may also have a starter motor but not sure.

[northwind]

Thanks TSM, but I shall pass on those. Should be fine for most purposes though, just not these misguided and potentially foolhardy ones :)