Log in

View Full Version : What could this be?


The Mass
13-06-06, 02:49 PM
I've managed to adjust the clutch, so it's not slipping.

However, when on a long journey, like this morning, I stop for petrol, to refill, and when I get back on to ride off its really clunky getting into gear up or down.
but when I pull the revs on, she goes easily or or down the gears.

and then when in low revs again, she gets really clunky? is this normal?

Cheers

Mass

Sid Squid
13-06-06, 03:46 PM
When you say 'adjust' if what you did was move the cable adjusters, then what you may have done is adjust the cable - not the clutch.

Try this:


Slacken off cable adjusters at top and bottom, loosen lifter locknut, back out screw a bit, ensure that lifter arm is as far down as it will go, gently turn screw in until it contacts pushrod, back it out a bit, (~1/8th of a turn), then nip up the locknut, roughly adjust cable with lower adjuster - not too tight - then with top adjuster ensure that there remains a little slack all the way from lock to lock.