Standard zorst compatability

[chunkytfg]

will a K6 one fit a K3? if not why not?

[on yer bike]

the k3 has a higher back, so if its a full system it may need some tweaking, to fit, if its just the can then u may need a modified link pipe

[northwind]

Yep, different subframe, should be OK otherwise. Doubt you've got a standard subbie anyway?

[FG1]

I asked the question today in my local Suzuki dealership. They are under the impression that as long as you have the K3 injected model, the system should fit.

[on yer bike]

My dealer didn't really know the difference between the k3 and k4-k6 until i was given the wrong part. It is subtle... I mean it will prob connect fine, I'm just not sure if the exhaust would connect to the hanger without either getting a different hanger, or bending the pipe, but it might.

[kwak zzr]

well if you buy a race can and state what model the link pipes are diff because of the rear sub frame.

[chunkytfg]

Yep, different subframe, should be OK otherwise. Doubt you've got a standard subbie anyway?

ahh dearboy you're getting all confused!! I have 3 SV650's. one standard K3 road bike, one minitwin spec K3 and a fire breathing K5 SV700!!

I was after a standard can to go on my road bike as it's only used to pottering behind the g/f on her hornet and it was bought after being thrown down the road so now i have the time over winter i thought i'd get it looking nice again.

I think i might just suck it up and get myself a nice aftermarket legel one instead. I spie a nice blue flame one f/s in the f/s section

[northwind]

I sees. Well, I'm pretty sure the only problem is that the hanger won't meet the can. Not 100%, but within spitting distance. So that's easily got around...