Tread Direction

[phil24_7]

The tread pattern on my Metzler Z6's appear to go in opposite directions. Is this correct??

The rear appears to rotate so that water would be pushed outwards away from the tyre but the front appears to run in the opposite direction so that water would be pushed into the centre of the tyre!

Anyone got Z6's that are fitted the same/differently?

Regards

[rictus01]

Can't honestly remember, but the manufacturer helps you out with a big arrow for rotational direction, I've had several sets of these and they work well as a pair in the wet (or mixed with the strada's).

:offtopic: (Slightly)

Interesting fact, haven't seen it in a while mind, but you used to get tyres that fitted one way round for the front, and the same tyre could be fitted the other way round to the rear, now that was confusing :confused:

Cheers Mark.

[the white rabbit]

I think there was a thread on this a little while ago with moulds being incorrectly labelled...or was that Continental?

[phil24_7]

Yeah I read that but I think it was the conti's.

Was just looking for some clarification on the Z6's.

Anybody goe a set they can check??

[Baph]

Looking from the back of the bike (and back of each wheel):

The rear has a strip down the middle with no grooves in it. The main grooves run down & out in a curve. There's a smaller groove that runs up as well.

The front, has a zigzag line running down the middle. Theres smaller grooves that run upwards & out as well.

[phil24_7]

Cheers.

I'll see if that makes sense in the morning when i'm looking at the bike!

[Jdubya]

Perhaps a few people could post pictures for comparison?:smt025

[Alpinestarhero]

The tread pattern on my Metzler Z6's appear to go in opposite directions. Is this correct??

The rear appears to rotate so that water would be pushed outwards away from the tyre but the front appears to run in the opposite direction so that water would be pushed into the centre of the tyre!

Anyone got Z6's that are fitted the same/differently?

Regards

Yea, i thought this too when my tyres where being fitted, but on the sidewall there is an arrow indicating the direction of rotation, which I have done correctly (i.e. the tyres rotate the correct way).

Matt

[Mogs]

Z6's have been out long enough for a mistake with the rotational direction to have been corrected. Avons have a similar pattern that looks wrong at the front.

[Baph]

Yea, i thought this too when my tyres where being fitted, but on the sidewall there is an arrow indicating the direction of rotation, which I have done correctly (i.e. the tyres rotate the correct way).

Matt

What about when you're pushing the bike backwards? Do the arrows point in the right direction then? :D

[phil24_7]

Arrows all point in the right dirrection it just looks like the tread pattern goes in opposite directions.