head bearing nuts

[kcowgergmm]

ok so i am in the process of a gsxr front end swap and i managed to use a punch and hammer to take the two i guess you would say two star shaped nuts that hold it on. Has any one else done this and i so is there a tool someone made i can see or be able to tell me where i can get one?

[northwind]

I use my trusty nail-with-the-sharp-bit-cut-off. But, you could probably find a c-spanner that would work, or modify a socket. There might be a suzuki service tool for it too.

[BILLY]

Yep I used a hammer and a small cold chisel:smt003

[Lozzo]

Buy an adjustable C-spanner from Hein Gericke. Then you can adjust your rear shock preload as well.

[kcowgergmm]

ok i found something that didn't work to bad i got them snugged up pretty well but not quite as tight as i think they were before but then there again im using diffrent parts. here is what i used from mac tools https://www.mactools.com/portal/site/mactools/menuitem.6c9db894a3743751f735c110f070c3a0/?vgnextoid=4d407734f5fdc010VgnVCM100000104d840aRCR D