| Dangerous Dave |
20-01-09 11:35 AM |
Re: Put my new bits on today
Micron didn't make a slip-on for the Curvy SV, only a full system, or is that a bodge job you have done?
Quote:
Originally Posted by Tim in Belgium
(Post 1741328)
I've heard sometimes you need to shove a broom handle up there to get it out, but that's only rumour and hear say.
|
Quote:
Originally Posted by Quiff Wichard
(Post 1751548)
i have scorpion with baffle on this and had to drill the rivet- then like tim says put a broom handle up the link pipe end and knock it out.
|
Thats the way to do it, remove the can only and then push a broom handle through the inlet side and knock the baffle out.
Quote:
Originally Posted by kwak zzr
(Post 1741652)
my microns were welded in.
|
Yes most of the Microns are welded, although I think it was the Delta+ which had the removable baffle. |
