SV650.org - SV650 & Gladius 650 Forum - Clutch not disengaging.

Quote:

Originally Posted by Sid Squid

Quote:

Originally Posted by BigApe

Quote:

Originally Posted by Sid Squid

Your new fully assembled clutch pack is, unsurprisingly, not the same thickness as the worn one, (which is good as there'd be no point replacing a worn one with another worn one), as the lifter only separates the plates by a few millimetres, a suitable adjustment is unlikely to remain if you were to change even one plate, let alone the whole friction set.

Do this:

Quote:

Originally Posted by I Previously

Slacken off cable adjusters at top and bottom, loosen lifter locknut, back out screw a bit, ensure that lifter arm is as far down as it will go, gently turn screw in until it contacts pushrod, back it out a bit, (~1/8th of a turn), then nip up the locknut, roughly adjust cable with lower adjuster - not too tight - then with top adjuster ensure that there remains a little slack all the way from lock to lock.

So, exactly how many times have you now posted that :?: :lol:

Very approximately 384,000 times.

Give or take a 5000 times or so.

Yeah, thought I had read it once or twice before. :lol: