Re: SVBMX Build Thread
 

Ah, fair enough! With east trax just down the road from you that sounds like a good shout. I've ridden there a few times on my brothers 250, much fun :)

Re: SVBMX Build Thread
 

Rough sketch! Perhaps something like this...

http://i.imgur.com/ABwrn51h.jpg

I'd keep it black as to not stand out too much!

Thoughts?

Re: SVBMX Build Thread
 

Beefs it up I bit, they do look a little skinny without a fairing down the front end.

Re: SVBMX Build Thread
 

Not so sure about that idea. The rest of the bike is compound curves, the belly pan is all straight lines.

But who am I to judge?

Re: SVBMX Build Thread
 

You've got a point there, maybe mirror the line of the from wheel more like in a regular belly pan.

Re: SVBMX Build Thread
 

I like it. Do it.

Re: SVBMX Build Thread
 

TAKE 2! Tried to take on board the above comments. Following the shape of the wheel and keeping to the curvy style. Much improvement i think.

http://i.imgur.com/MAPvMqSl.jpg

Thinking i could make it from some sheet aluminium, and have it powder coated black to match the engine black. And could possibly fill the V-shape (front view) with a black mesh of sorts.

Re: SVBMX Build Thread
 

Tbh, I prefer it without either ☺

Re: SVBMX Build Thread
 

It is an improvment but I think itll look too tall, if you bring the bit nearest to the wheel up away from the floor a bit, it might help - rather than it being straight at the bottom it would snake upwards.

Might look worse tbh, just a thought

Re: SVBMX Build Thread
 

Sketched an alternative angle...

http://i.imgur.com/lSSTiZml.jpg

I'm not sure how it will really look until i actually mock something up.
And i'm not entirely convinced myself about the whole thing! But i do like the idea of doing something a bit outside the box. I think maybe a vertical vent cut into each side would break it up a little.