Block connector terminals/inserts
 

The large white block connector in the left hand side of the front fairing on my curvy has been playing up. The power feed to the speedo, tacho, and fuel light was iffy and when I checked it the female terminal had rotted. I made up a short bypass cable for it and all was well again - until I tried the headlights and discovered that the dip beam was now playing up. Gently juggling the block connector made it come on and go out.

I'm going to make up another bypass cable for it temporarily but what I actually want to do is find a pack of the correct size of terminal inserts. Not had much luck so far in my search so does anyone else have a supplier of these things to which they can point me please?
Cheers.

Re: Block connector terminals/inserts
 

gives a pic of the connector as i may have the terminals you require...

Re: Block connector terminals/inserts
 

Thanks chaps but I've sorted it now. The terminal for the dip beam was clean enough, it just needed popping out and squeezing up a bit as it was loose on the male/spade half of the connector.
I also managed to by a dozen compatible connectors at my local car spares place in Welshpool. They're a different design but the essential dimensions and fit look to be the same.

Re: Block connector terminals/inserts
 

make sure that the locking tab on the terminals is the same.. been there done that.. lol