sv650n k3 gear lever removal problem
 

Hi everyone
So after taking bits and pieces apart to clean/grease/oil I decided to do the foot peg assembly's, to keep it short, when I tried to remove the gear lever from the pivot point that also holds the LH foot peg to the hangar plate it would not budge. It still swivels on the pivot although it feels ever so slightly stiff. The bike has been down on the left side sometime in its life before my ownership so I was wondering if that had anything to do with it but the signs do not really show a hard enough drop to bend the whole pivot point and not the hangar plate. Tried pulling it off the pivot by hand, hitting the pivot through the lever with a hammer, lots of jiggling about ect...

Any ideas for the cause or a solution are greatly appreciated.

Many Thanks
Craig

Re: sv650n k3 gear lever removal problem
 

Very common - and when stuck in this manner removing it usually destroys the (non replaceable) bush inside the lever pivot hole.

If it's still free enough and working properly, put it back together with a good squirt of oil into the pivot as best you can.

Re: sv650n k3 gear lever removal problem
 

Ta squid, is the bush like a sleve with a small lip over the edge of the gear lever where it sits against the mounting plate? If so it was looking a bit worn and battered but still in one piece.
Yep that's what i did, it'll hold up for the mo while im trying to figure out what to do with it long term.

Craig

Re: sv650n k3 gear lever removal problem
 

The pivot has a grease groove around it circumferentially in the middle, the inner face of the lever corrodes and squeezes the bush into the groove just enough to make it a ridge that won't pass over the pivot.
As said, if it's working well enough, leave it alone. Removing it will very probably break something, usually the bush and that's a pain in the bum. I have previously made a new bush from a plastic sleeve, but it's a fiddly-a**e job.

Re: sv650n k3 gear lever removal problem
 

Cool thanks for the advice, i was thinking about getting a new lever as mine is ever so slightly bent but would a new one come with a new bush inserted in it?

Craig

Re: sv650n k3 gear lever removal problem
 

Yes.