K3 rear wheel bearing sizes
 

What are they please so i can order some for my curvey wheel.

Cheers


Oh...Where is the best place to get em from?

I don't know the codes for them mate,(But if you gently tap the existing one's out using a suitable drift and hammer...you will be able to read the engraved code on them) Your smartest bet is to source them through a local Engineer suppliers or bearing factor. The codes are used to tally up the right item no matter who the maker is.
With a bit of basic skill there is no big deal to removal and replacement of wheel bearings.Good luck.
Avoid Suzuki prices if at all possible. :wink:

I have a curvy rear wheel to go in a pointy though so the bearings i remove wont match the ones i need. :?:

Got my wheel bearings for my k3 from this company, a lot cheaper than suzuki


http://www.thebearingshop.com

Good point,is the axle bolt the same diameter on both models?

nope. hence needing the sizes

Re: K3 rear wheel bearing sizes
 

Wheel bearing 20x47x14

Cush Drive 25x62x17

Cheers
Ben

Re: K3 rear wheel bearing sizes
 

cheers quest. using that site mention above i've foubnd the ones i need apart from one thing. There are three different bearings listedin thats size.

A 6204, a 6204 2RS and a 6204 ZZ. Whats the difference and wat one do i need?

2RS - 2 rubber seals (withstand water getting into the bearing)
ZZ - Double Metal Shield (does not withstand water)

AFAIK From what i have read.

2RS are the ones to go for i was told when i needed to get mine.

Just go for 2rs, this is just what type of seals are fitted (if at all).
2RS is 2 rubber seals
ZZ is metal sheilds

PDQ have them in stock, most dealers should have as just about all honda's and some Kwaks have 6204's in their front wheels