My **** - tail tidy
 

ok so today i started work on making my own tail tidy and under tray and this is how far i am at the moment.

http://i102.photobucket.com/albums/m...5/DSC00679.jpg
http://i102.photobucket.com/albums/m...5/DSC00680.jpg
http://i102.photobucket.com/albums/m...5/DSC00676.jpg
http://i102.photobucket.com/albums/m...5/DSC00678.jpg
http://i102.photobucket.com/albums/m...5/DSC00681.jpg

i am at this minute waiting for the primer to go off then i will spray them, assemble the tail tidy, bolt or rivet (mind not made up yet) it to the under tray and wire up the indy's and all will be done

Re: My **** - tail tidy
 

Cool.

Re: My **** - tail tidy
 

Good work there.
post some photos of the item when finished.

Re: My **** - tail tidy
 

:smt038 Looking damb good i must say. Make a few and sell them. People on here are always asking for them.

Re: My **** - tail tidy
 

Nice job :cool:

Re: My **** - tail tidy
 

i may even make my way down to you so you can fit it for me!! ;)

Re: My **** - tail tidy
 

will do

tar very much :p
the making it isn't the hard part, its the cutting away of the plastic on the bike

your turn :-D

just added final coat of paint so will go and finish it in about a hour, just held the number plate up to it and its mahoosive lol i will be getting me dad to make me up a slightly smaller one :smt045

Re: My **** - tail tidy
 

LOL! don't think i want to be doing it again though, i made a slight balls up when cutting away the plastics and i have a 5mm gap but its not noticeable from the outside so i will put a bit of fibreglass over it from the inside

Re: My **** - tail tidy
 

ah will finish it tomorrow, have missed a bit when i was spraying so i have to give it another coat:rolleyes: wait until tomorrow me thinks

Re: My **** - tail tidy
 

Nice job mate, I think I'll have to do this to mine at some point