Jelly Rabbit?
 

My daughters been ill, so I took the day off work to be with her
We made some chocolate cookies this morning, from a women's institute recipie:D (yummie, those old birds new what they were doing)
and then we made some jelly.
Green jelly in a thin metal mold, in the shape of a rabbit
every thing went OK, it set OK,
But my question is..

How on earth do you get it out of the mold without scrambling it?:confused:

Matilda was a little upset, so Daddy said he would consult the fountain of knowledge:notworthy:

Re: Jelly Rabbit?
 

Assuming it's properly set, surely just flip and tap it?

Re: Jelly Rabbit?
 

That's what we tried
The suction was soo much, it wouldn't release
until more frantic shaking and tapping resulted in the jelly reaching its yield stress resulting in a mushy mess:(

Re: Jelly Rabbit?
 

I just called a girl i know, apparently you should put the outside of the mould in hot water and it will slide out.

I don't know if that will work for sure. :)

Re: Jelly Rabbit?
 

Yeh, it will. Then stick it back in the fridge for a bit. Should do the trick

Re: Jelly Rabbit?
 

I will try that
The warmth may melt the jelly again
I should have thought of that
Thanks:D

Re: Jelly Rabbit?
 

Used to pour the kettle over the metal mould, then lift it off

Re: Jelly Rabbit?
 

Definitely put the mould in warm water to release it!

Re: Jelly Rabbit?
 

Obviously I don't mean submerge it, keep the "entrance" to the mould above the water does not contact the jelly....

Re: Jelly Rabbit?
 

+1 on the warm water on the out side of the mold then turn onto plate.