SV650.org - SV650 & Gladius 650 Forum

SV650.org - SV650 & Gladius 650 Forum (http://forums.sv650.org/index.php)
-   SV Talk, Tuning & Tweaking (http://forums.sv650.org/forumdisplay.php?f=111)
-   -   What to do with my carb settings? (http://forums.sv650.org/showthread.php?t=128905)

r4ce_e3nd 01-04-09 05:52 PM

What to do with my carb settings?
 
A few weeks a go I had the chance to a dyno-run for free and it revealed in the curve below...

At the moment my bike has a Dyno-set stage 2 adjusted by a dealer here nearby. Actualy I think he just put the carbs of my previous SV (also adjusted by him, and which had some holes in the air filter to make it breath better) put in my current bike without touching it.

It also has the cam-mod done and tankspacers + Akra line.

You can see he runs much to rich, especially until 6500 rpm +-11 air/fuel. :o

My question: what do I have to do with my carbs? As I have non experience with it and would like to do it myself (for once :rolleyes:)...

I want to keep the stock (new) filter and at the end the cunsumption should be less, I hope.

Thanks in advance.



http://img5.imageshack.us/img5/2624/powercurve.jpg


Blue: 75,5bhp and 68Nm (this dyno has a bad reputation of being very NOT optimistic)

SVDragRacer 02-04-09 07:40 AM

Re: What to do with my carb settings?
 
If its running rich at the lower end of the rev range i'd say you'd want to adjust the air fuel mixture screw (2 to 2 1/2 turns seems to be the norm) to begin with. After that it may be worth looking at the pilot jet size and maybe down sizing, then maybe even the main jet and needle level depending on how things are towards the top end.

You could always get another filter like a BMC race one with the big ol' hole in it or de-snorkel a normal one, rather than drop the fueling you'd increase air flow.

HTH

yorkie_chris 02-04-09 02:04 PM

Re: What to do with my carb settings?
 
Drop the needle a bit

Viney 02-04-09 02:07 PM

Re: What to do with my carb settings?
 
What ^^^he^^^ said. 1 Notch shold do it

r4ce_e3nd 02-04-09 04:58 PM

Re: What to do with my carb settings?
 
Ok, thanks. I will have a look at it. :)

yorkie_chris 02-04-09 05:47 PM

Re: What to do with my carb settings?
 
A notch or maybe just a washers thickness. Above 12:1 is near enough.

Does it feel definitely flat low down, especially when hot?

With 1.5 notches worth of being too rich mine was very sloppy and wouldn't blip cleanly after 5 minutes or so of fast cruise.

johnnyrod 03-04-09 12:47 PM

Re: What to do with my carb settings?
 
I'd go with Chris' recommendation, adjusting the pilot won't help that far up the rev range on full throttle


All times are GMT. The time now is 02:11 AM.

Powered by vBulletin® - Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.