Fitting Clip ons
 

Just trying to fit clip ons back on as the bike currently has renthals. It has a new top yoke to take the current bars. Looking at fitting the clip ons today and at the manual I have.

Question - I presume that there should be a hole in the underside of the top yoke to locate the clip ons? Can't see any on this yoke so do I have to try to find an original yoke?

If so do any other top yokes fit (from any other bikes) or only from a SV1000?

Re: Fitting Clip ons
 

Just SV1000 ones I think.
However you don't need any bolt or hole. Just stick them back on, if they've got a locator tab or pin, then chop it off. If they've got a hole to bolt through, ignore it. They're fine just with friction from the clamp bolt.

Re: Fitting Clip ons
 

Cheers, any tips for positioning them without the locator then? Or best just to try them and adjust if necessary?

Re: Fitting Clip ons
 

I would just get the right yoke if i were you.

Re: Fitting Clip ons
 

That's what I'd rather do but they seem very hard to come by. If I could get one I could then sell the one fitted for the renthals but it's just trying to find one.

If any one happens to have one then please let me know :)

Re: Fitting Clip ons
 

Try and find out others that are the same. I can tell you for a fact that K1-K3 GSXR 600 does not fit although it looks identical it is 1mm smaller at the stanchion!!!!!