Curvy Starter motor
 

As above need a starter , must be in good condition and able to unscrew the terminal nuts as this is cause of mine breaking.

Need as soon as possible.

Ash.

Re: Curvy Starter motor
 

You want to send me yours and see if it can be repaired?

Re: Curvy Starter motor
 

tbh i could probably repair it but none of the spanners i have are thin enough to get round the second nut.

Actually look at this, im not sure you can buy the insulating washers by themselves so im not sure.....

Re: Curvy Starter motor
 

Don't think you can, just make them.

Re: Curvy Starter motor
 

Bump!

Re: Curvy Starter motor
 

i'll be removing an engine tomorrow so will get back to you regarding the condition of the one i take off

h.

Re: Curvy Starter motor
 

as long as the armature is in good nick, the rest can be easily fixed, done about 15 of these myself, 3mm industrial rubber sheet for the washers and copper braid to replace the connection, the boly can be chopped off if it's totally fubar'd, but easy enough to lock the inside square block in place and use a spanner normally.

Cheers Mark.