![]() |
Bibio's carb tail kit fitted
Finally got around to fitting the carb tails. Swine of a job getting at that front vacuum take-off! Made easier by using a smear of vaseline to ease it on (ooerr missus!) and a small cable tie to ensure it stays put. Nice little kit.
http://i12.photobucket.com/albums/a2...s2_800x600.jpg Couple of other jobs while I was at it - cleaned and re-oiled the air filter. http://i12.photobucket.com/albums/a2...er_800x600.jpg And refilled the Scottoiler http://i12.photobucket.com/albums/a2...er_800x600.jpg That rear subframe will be coming off this winter for a repaint! Jobs for tomorrow morning will be to check the carb balance and then give the bike a long overdue clean! |
Re: Bibio's carb tail kit fitted
Good stuff!
Mine ain't that tidily routed. You can also replace the vac hose and use the tee and strap them there |
Re: Bibio's carb tail kit fitted
excellent. looks a good place to put the p clips.
keep an eye on the the ends if you lubed it to get it on as it could pop off. |
Re: Bibio's carb tail kit fitted
It was only the front vacuum take off that got the smear of vaseline Lance, and I put a small cable tie around it to ensure that it stays put.
Balanced the carbs this morning and it was a nice easy job with the new tails in place. |
Re: Bibio's carb tail kit fitted
sound. it's nice to get feedback on products.
thanks m8 |
Re: Bibio's carb tail kit fitted
You're very welcome - credit where it's due I say!
Now then, was there some talk about curvy wheel adjuster plates this winter? :notworthy: :lol: |
Re: Bibio's carb tail kit fitted
i'll hopefully be getting those sorted over the winter :-)
|
All times are GMT. The time now is 06:14 PM. |
Powered by vBulletin® - Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.