SV650.org - SV650 & Gladius 650 Forum

SV650.org - SV650 & Gladius 650 Forum (http://forums.sv650.org/index.php)
-   Bikes - Talk & Issues (http://forums.sv650.org/forumdisplay.php?f=129)
-   -   Gpz500 engine help (http://forums.sv650.org/showthread.php?t=187391)

Joe Marcon 22-11-12 02:04 AM

Gpz500 engine help
 
Just bought a quadzilla 200 with a kawazaki 500 gpz engine in. And the left hand cylinder (sitting on bike) has stopped . I started it up didnt hold idle so knew it dropped a cylinder saw fuel leaking from the cylinder, either from exhaust studs or somewhere else :S, if the coil pack has packed im would this make the cylinder leak fuel as its not sparking it? Or is it something else . Only just got it and its been gay lol :(. I thought it was carbs,
But its not

joshwalker094 22-11-12 07:28 AM

Re: Gpz500 engine help
 
Could the fuel line have come off? I wouldn't have a clue tbh, that's why I ask org too

mikerj 22-11-12 12:35 PM

Re: Gpz500 engine help
 
How do you know it's not a carb problem? Have you actually checked for a spark?

Biker Biggles 22-11-12 12:46 PM

Re: Gpz500 engine help
 
If petrol is pouring out of the cylinder I would think its a carb problem.Probably a stuck or sunk float or a crudded up valve allowing fuel to flow constantly from the tank into the carb,then flooding into the engine,then coming out somewhere.

Joe Marcon 22-11-12 02:06 PM

Re: Gpz500 engine help
 
Well im going to test ht lead against engine for spark. I do think its the carbs now lol . New carbs or??

Joe Marcon 24-11-12 01:53 AM

Re: Gpz500 engine help
 
Had them cleaned by YC. Run fine . And now its doing it again :@ damn poo gpz engine

NTECUK 24-11-12 12:40 PM

Re: Gpz500 engine help
 
Migh be poo in the tank???
http://www.angelicdreamz.com/thumbna...x=320&maxy=340

Joe Marcon 24-11-12 12:58 PM

Re: Gpz500 engine help
 
Haha . Gunna check and stick a fuel filter on

Whitty 24-11-12 01:12 PM

Re: Gpz500 engine help
 
Dont blame the poor old gpz engine. My old k reg commuter hack starts first time, pulls well and has never dropped to one cylinder! Sounds like float sticking/crud under needle. Have you been out in wet(i know its hard to avoid) or off road? Wondered if it had got moisture to it, I have heard gpz were prone to it though mine hasn't.

Joe Marcon 24-11-12 01:23 PM

Re: Gpz500 engine help
 
Haha i been on fields and thats it . Gunna get new spark plugs . And coil packs .


All times are GMT. The time now is 02:54 AM.

Powered by vBulletin® - Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.