Curvy Parts
 

Time to clear some space in the Shed, from the winter of tinkering and evil!
There will be some more parts in the next week or so as I get through the shed. :)

I do have the odd GSXR 600 K1 bit knocking round and a couple of bits that can be used on other bikes, I'll list them up later

First up...
Curvy Lower Yoke: £30 posted.
This one is off my bike, it was swapped with another one which was cleaned and sprayed up the same. Its been degreased and the spot rust taken off, then sprayed with 2 coats of Silver Plasticote Fast Dry enamel.

http://i1034.photobucket.com/albums/...pscd673016.jpg

Curvy brake torque arm £10 posted
Its a bit tatty, given a p*** poor coat of silver paint. Its all solid under the paint. Its a poor standard for me refurbishing parts hence price.

http://i1034.photobucket.com/albums/...ps8a007ba2.jpg

Rear Caliper Hanger £10 posted
This is in a good clean condition, sprayed up the same time as the lower Yoke. Mine again is done the same way and this lasted 2 years out in most weathers and it lives under cover in the outdoors

http://i1034.photobucket.com/albums/...ps7507cf01.jpg

Lastly for this pile
Front pads £12.50 posted

Well I seem to amass these types of things over a few months and they need to go! No brand, but look like Sintered/ HH (if you work in EBC spec) and good for about 7k (if not more)

http://i1034.photobucket.com/albums/...ps55d1a594.jpg


Thanks
Andy

Re: Curvy Parts
 

Top floor stop with a bump

Re: Curvy Parts
 

Bump