Help with getting bike running - Hereford area.
 

Anybody local to hereford area fancy helping me get my curvy running?

Bike turns over but won't catch! I can smell fuel from the exhaust just unsure where to start looking!

Bike has been stood but has fresh fuel and is connected to my car via jump leads to help it keep cranking

Bike has been cranked for about 10 minutes in 30 second bursts so I don't bugger the starter

So guys where do I start?

Re: Help?!
 

First pull spark plug after trying to crank the bike - is it wet?

If wet then fuel is getting into cylinder but not combusting.

If dry then fuelling issue - no fuel getting into cylinder

IF you are getting fuel into cylinder then the next step is to check for a spark - pull the HT lead off the plug and stick a screwdriver or something of the sort into the HT lead. Hold onto the plastic handle and hold the side of the screwdriver about 1 cm away from engine block - use common sense, don't hold onto metal part - you'll get a shock, and obviously don't try near fuel!

When you crank the bike you should see very obvious sparks grounding on the engine block.

No spark - electrical fault (sensor / ignition coil, etc)

Spark - then in theory bike should be trying to go

This a start in diagnosing whats up with it.

Hope it helps

Re: Help?!
 

Thanks for that will give it a pop when it's light out

Re: Help with getting bike running - Hereford area.
 

Thanks for the input just put a new battery in and cleaned the rear plug started on 1 cylinder then spluttered into life. MOT is booked in for next week now

Re: Help with getting bike running - Hereford area.
 

If you do a search on here for choke plungers you will find some useful information.Its a good idea to service the choke plungers and cable on a curvy regularly as they often cause poor running if left.

Re: Help with getting bike running - Hereford area.
 

Just bought a haynes for the bike today will have a nosy

Thanks