Stainless adjuster plates.....................bling
 

Just ordered some adjuster plates for my curvey, made to order by a guy called
Paul Rowse at crazydevelopments@hotmail.co(dot)uk
only £9.35 for both plates and postage

If anyone wants some, give him an e-mail
The sizes are 35mm x 50mm x 3mm with a 16mm hole in the middle

Would they fit a pointy?

Don't think so, the adjuster mech is completely differant IIRC

This thread is pointless without pictures :lol:

As soon as i get them I'll post pics.......................that'll be about 10 days :wink:

Eh, 17mm surely?

Anyway, this is to formally advise you that I'm stealing your idea.

No surprise there, i did tell the guy i'd get him at least 1 more order.............not that i knew you'd "steal my idea" :-dd

The rear axle bolt (acording to the rear axle nut(acording to tasty nuts website)) is M16 Which i also have found a stainless alernative for (pac of 2 if anyone wants 1)

I'm almost totally sure it's 17mm. Certainly that's the number that's always quoted. I've never measured one though. Were I you, I'd find out pretty quick ;)

I hope he got them right. Looked into getting some made but got side tracked with other things.

To make them the way I would be happy with, the plates for either side would have to be a different dimensions as well :wink:

What grade is he using?

Cheers
Ben

The bolt and nut are M16 (I Measured) I'd rather it tight so i could open it out then sloppy and be unhappy :wink: The other measurements are right cause I measured the plate before ordering
Not sure...to be honest i don't mine......so long as it lasts longer then the sh8 on there now :lol: