R&G Racing Accesories
 

Crash protectors and bar ends, are they easy to fit?

How do you do it?

quite easy on the SV, there are a newer verion out know, which have mounting brackets on them.. you take out the engine bolts and put the brackets on the new set.. then put the bungs into the bracket...

bar ends I wouold think are exactly the same to put on and take off as the ones on the bike, undo the bolts slightly (not all the way) and pull the bar en out of the bar, this should bring the expanding bolt inside out with it... depending on if you have to get that out to put the R&G ones on... then put new bar ends onto the bolt, and feed back into bar end.. and tighten up

there a good investment on a k3 mate as the radiator is v wide and would be one of the first parts the touch the ground in the event of a drop.