Showing results 1 to 25 of 127
Search took 0.01 seconds. Search: Posts Made By: philbond07 |
Forum: SV Talk, Tuning & Tweaking 30-08-18, 07:53 PM |
Replies: 5
Views: 1,662
Posted By
philbond07
Re: In praise of Yuasa batteries
My genuine Yuasa died today, K3 naked, 15 years of service, kept it on conditioner regularly. |
Forum: SV Talk, Tuning & Tweaking 27-08-18, 09:24 PM |
Replies: 27
Views: 4,263
Posted By
philbond07
Re: Advice Please: Head stock bearing tightening?
Ok got all that. Will continue playing with it next weekend with all the knowledge I learned here. Looks like I mainly will have to apply considerably reduced forces. Thanks a lot for help &... |
Forum: SV Talk, Tuning & Tweaking 27-08-18, 04:19 PM |
Replies: 27
Views: 4,263
Posted By
philbond07
Re: Advice Please: Head stock bearing tightening?
Ok tx Bibio, sucking in information here. I've made myself an overlock stand to raise the front already some time ago, it works with a 10mm rod that goes in a hole in the engine block. So all my... |
Forum: SV Talk, Tuning & Tweaking 27-08-18, 02:21 PM |
Replies: 27
Views: 4,263
Posted By
philbond07
Re: Advice Please: Head stock bearing tightening?
Ok check that good lesson :( Do you think the top yoke nut is also overspecced at 90Nm? |
Forum: SV Talk, Tuning & Tweaking 27-08-18, 11:58 AM |
Replies: 27
Views: 4,263
Posted By
philbond07
Re: Advice Please: Head stock bearing tightening?
Hey Craigg ok about that nor tensioning top adjuster nut, nor top yoke nut should influence bearing tension, even not at 80Nm I think. But 80Nm effectively sounds too much on a alu nut. Guess there... |
Forum: SV Talk, Tuning & Tweaking 26-08-18, 11:09 PM |
Replies: 27
Views: 4,263
Posted By
philbond07
Re: Advice Please: Head stock bearing tightening?
Hey all, Sry for reviving old thread. I wanted to check out stock head bearings of my naked k3 and also tighten up a bit cause it felt a bit loose. So regreased the bearings; races up/down... |
Forum: SV Talk, Tuning & Tweaking 25-10-12, 12:11 PM |
Replies: 11
Views: 1,310
Posted By
philbond07
Re: Oil change confusion
Yes well that's how it should be done, did it like that past 9 years. But not this time. I am quite sure though I put 2.5 liters in there initially, according to indicators on motul 5100 10w40... |
Forum: SV Talk, Tuning & Tweaking 25-10-12, 09:28 AM |
Replies: 11
Views: 1,310
Posted By
philbond07
Re: Oil change confusion.
Hehe thanks for the empathetic approach of telling me chances are slim nothing at all has happened. Can live with that. |
Forum: SV Talk, Tuning & Tweaking 25-10-12, 08:48 AM |
Replies: 11
Views: 1,310
Posted By
philbond07
Re: Oil change confusion.
Pfffrt had a similar issue recently after oilchange on my K3 before winterstop. New hiflofiltro filter, initially put in like 2.5liters in total, included prefilled filter. But since I was in a... |
Forum: SV Talk, Tuning & Tweaking 28-07-11, 07:44 AM |
Replies: 7
Views: 2,215
Posted By
philbond07
Re: glysantin g30 coolant?
ryt, we'll be waiting for ur feedback, then finally evaluate what coolant to mount. |
Forum: SV Talk, Tuning & Tweaking 27-07-11, 06:54 AM |
Replies: 26
Views: 4,161
Posted By
philbond07
Re: suspension mods?
Gentlemen, gentlemen, keep your calm. I've been looking for a way to put the rear of my K3 bike a little heigher, since the front went up considerably after installing progressive forksprings. I... |
Forum: SV Talk, Tuning & Tweaking 25-07-11, 01:19 PM |
Replies: 7
Views: 2,215
Posted By
philbond07
Re: glysantin g30 coolant?
In fact, the Toyota Longlife red coolant appeared to be a HOAT already, containing benzoate as organic acid, and phosphates of course. Found back the link why phosphates could be dangerous in... |
Forum: SV Talk, Tuning & Tweaking 23-07-11, 08:46 AM |
Replies: 7
Views: 2,215
Posted By
philbond07
Re: glysantin g30 coolant
There seemed to be another danger with hi-phosphates/no-silics coolants, beside risk of mixing with hard water, that european coolant engineers were afraid of; cannot remember. I think under certain... |
Forum: SV Talk, Tuning & Tweaking 22-07-11, 05:58 AM |
Replies: 7
Views: 2,215
Posted By
philbond07
Re: glysantin g30 coolant
yeah the old toyota red is an IAT with no silicates, lots of phosphates. If mixed with distilled water it will give no problems and no risk of silicate fallout. Here in Belgium I cannot find it... |
Forum: SV Talk, Tuning & Tweaking 21-07-11, 10:38 PM |
Replies: 7
Views: 2,215
Posted By
philbond07
glysantin g30 coolant?
Anybody used this coolant for a while without problems? I cannot find if this OAT uses 2-eha which is known to be a plasticizer and thus might just dissolve the sv's plastic waterpump impeller,... |
Forum: SV Talk, Tuning & Tweaking 06-08-10, 10:25 AM |
Replies: 536
Views: 118,161
Posted By
philbond07
Re: rear shock change
Great, need to know cause I want to raise my K3-n's tail like 35mm. 96-99 GSXR750 shock would be best then. There was also a dogbone-shortening/tail rise ratio if I remember well. Tx, Phil. |
Forum: SV Talk, Tuning & Tweaking 06-08-10, 08:04 AM |
Replies: 536
Views: 118,161
Posted By
philbond07
Re: rear shock change
Hey Badger, this means stock length has increased like 2.5 mm from stock. In how many mm tail-raising does this xlate? Cheers, Phil |
Forum: SV Talk, Tuning & Tweaking 04-08-10, 08:03 AM |
Replies: 12
Views: 1,665
Posted By
philbond07
Re: cracks in rear sprocket drum?
To be honest, I thought I was finally able to control myself. And now this again. All these years of Yoga training - all for nothing. |
Forum: SV Talk, Tuning & Tweaking 04-08-10, 07:21 AM |
Replies: 12
Views: 1,665
Posted By
philbond07
Re: cracks in rear sprocket drum?
There was nothing to be seen at back of bolts I guess. Just wanted to try get them out before taking a grinder; have no access to a nut-cracker. But what do you think of the sprocket drum... |
Forum: SV Talk, Tuning & Tweaking 04-08-10, 07:08 AM |
Replies: 12
Views: 1,665
Posted By
philbond07
Re: cracks in rear sprocket drum?
I can't see how this should help me. The bolts/nuts are spinning simply because they are stripped. This of course has nothing to do with the special shaped bolt head not being housed in proper... |
Forum: SV Talk, Tuning & Tweaking 04-08-10, 07:03 AM |
Replies: 12
Views: 1,665
Posted By
philbond07
|
Forum: SV Talk, Tuning & Tweaking 04-08-10, 06:56 AM |
Replies: 12
Views: 1,665
Posted By
philbond07
|
Forum: SV Talk, Tuning & Tweaking 03-08-10, 10:44 PM |
Replies: 12
Views: 1,665
Posted By
philbond07
cracks in rear sprocket drum?
Hi all. I managed to strips 3 of the 5 bolts attaching the rear sprocket to the rear sprocket drum. The nuts are turning loose on the bolts and cannot be removed. Stupidly enough, I smashed onto... |
Forum: SV Talk, Tuning & Tweaking 05-04-10, 09:29 PM |
Replies: 26
Views: 6,023
Posted By
philbond07
Re: steering head bearings
Ok Gentlemen, tx to u all for your help. Trying to find new pieces tomorrow. |
Forum: SV Talk, Tuning & Tweaking 05-04-10, 07:07 PM |
Replies: 26
Views: 6,023
Posted By
philbond07
Re: steering head bearings
ok the plan is: - let the stem rethread, local to the "nicks" in order to get rid of them, guess rest of stem thread is ok. - clean up rest of stem - get new alu stemnut - leave upper & lower... |
Showing results 1 to 25 of 127 |