27-09-06, 08:08 AM
|
#11
|
|
The Sick Man
Mega Poster
Join Date: Nov 2004
Location: Peckham.SE.LDN
Posts: 4,768
|
Quote:
|
Originally Posted by northwind
Quote:
|
Originally Posted by BigApe
I don't go anywhere near a torque wrench when a steel nut is going into alloy.
|
Yup, but you know what you're doing. Most folks don't know how tight to make a sump bolt, without a torque wrench and a manual... |
Then they strip it. I always take a fair bit of torque figures that are in the haynes manual.
__________________
OTR: KTM 690 Duke R 2015 Full Akro
SIDELINE: Kwak ZX636 A1P 2002, Red, R&G's, Yoshi, Double Bubble Screen
GONE: Kwak ZX-7R P1, Full Akro, Undertray, Screen
GONE: SV650S K2 Very Bruised & Without Fairing, Motovation Frame Sliders, R&G Ally Sprocket Toe Protector, HEL 2 Line Setup, GSXR K1 600 RWU Forks, Barnett Clutch & Springs, Penske 8981 Shock, Gilles Ti Rearsets, Steel Barends, Scottoiler, AFAM Chain & Sprockets, Twin FIAMM Horns, Skidmarx Bellypan, Full Micron Zeta Steel System, Cut down undertay.
Forum Problems & Information / Site Suggestions
|
|
|