SV650.org - SV650 & Gladius 650 Forum - View Single Post - GSX-R Front end conversion

05-12-07, 01:00 AM

Abba stand was £85 from the NEC.

Just strip clip-ons, remove top yoke, remove clip-ons, trace the speedo sensor wire up to the frame and disconnect (you'll have to cut the cable ties attatching it to the brake line) and release the head stem. Forks and yokes will drop out a piece of pi55.

My advice came from someone who didn't realise I was swapping the yokes as well.

First major bit of work I've done to my bike and it went better than expected, I'm hoping it goes back together just as easily.

05-12-07, 01:00 AM	#5
phil24_7 Guest Posts: n/a	Re: GSX-R Front end conversion Abba stand was £85 from the NEC. Just strip clip-ons, remove top yoke, remove clip-ons, trace the speedo sensor wire up to the frame and disconnect (you'll have to cut the cable ties attatching it to the brake line) and release the head stem. Forks and yokes will drop out a piece of pi55. My advice came from someone who didn't realise I was swapping the yokes as well. First major bit of work I've done to my bike and it went better than expected, I'm hoping it goes back together just as easily.