Quote:
Originally Posted by lucky strike
Being a handy Engineer myself (!) I would take some suitable studding (i.e. threaded rod), gently heat up with a blow-torch or the like, and bend as required. For a nice finish, some matched heat shrink placed all the way around the u-bend, leaving about 10mm at either end, and shrink to size. Et-voi la!
|
I was quite tempted to do this actually.
Half-wits do only do u-bolts for exhausts no smaller than 3" I think (at least when I last looked) - I've tried wickes but not B&Q yet, may try them tonight.
1" is 25mm right? I wanted a tight fitting one really so may end up making them.
Tomtom's fitting kits are really crap, thats why I've resorted to making one! The tomtom rider would fit really snuggly between the two risers.