Quote:
Originally Posted by northwind
It's not hard to do, it's just hard to do without being either spendy or unreliable  If mine doesn't clear 80 on a DJ machine once I do the busa pistons it'll be a bit of a letdown though. |
Not convinced on the busa pistons myself as they're intended for nickasil bores where the expansion rates are all different so the piston to bore clearence is critical and the only gain is from thinning the headgasket, but thats only very slight as the compression would be lower than stock if you put them straight in.
It will need the compression ratio testing and the barrells skimmed to suit for best results, but your still bolting it to the weak links of crank and rods, and there's no subsitute for cubes
