SV650.org - SV650 & Gladius 650 Forum - View Single Post - Symtec heated grips

30-01-09, 03:45 PM

Use the thick orange wire at the fusebox. It's an ignition switched live and the one all the other heated grips makers recommend you use. Don't scotchlok into the wire, it'll cause a lot of resistance and leave it open to corrosion, carefully strip it back and solder in a feed off it and fit the fuse as close to the fusebox as possible for safety and ease of access. Remove the battery from the bike first and only reconnect it when every connection has been properly made and insulated.

30-01-09, 03:45 PM	#2
Lozzo Guest Posts: n/a	Re: Symtec heated grips - fitting advice? Use the thick orange wire at the fusebox. It's an ignition switched live and the one all the other heated grips makers recommend you use. Don't scotchlok into the wire, it'll cause a lot of resistance and leave it open to corrosion, carefully strip it back and solder in a feed off it and fit the fuse as close to the fusebox as possible for safety and ease of access. Remove the battery from the bike first and only reconnect it when every connection has been properly made and insulated. Last edited by Lozzo; 30-01-09 at 03:48 PM.