SV650.org - SV650 & Gladius 650 Forum - View Single Post

29-03-09, 05:41 PM

Went to the Wirral Egg Run today and bike was fine until we decided to stop for food . Was about to pull into a car park and the bike stalled , fired her up again and had to give it a bit of gas to get her into the car park . It`s a K3 SV650s . The Idle speed was quite high so I adjusted that down a touch when I got to the car park as well . Once the bike had cooled down she seemed to be ok and the run home was fine . I popped into work to do an hours overtime and she was fine leaving work , I refuelled and as soon as I started her she stalled .

Managed to get her going and gave it some gas and she seemed fine until I got to a set of lights near home , it seemed like she was running on one Cylinder and was popping and spitting . Got her home and let her cool down for a bit and then went outside to check her over . She fired up and went into fast Idle as usual and when she went to normal Idle I made sure it was set to 1300 rpm , the thing is now , when I raise the revs to about 2k to 3k she seems fine for a second then cuts , the lights dim a fraction , she picks up again and can randomly cut out of start chugging like a bastage and the Idle drops to around 1000 ...... any ideas ?

29-03-09, 05:41 PM	#1
xXBADGERXx Guest Posts: n/a	Running like a sack of Poo Went to the Wirral Egg Run today and bike was fine until we decided to stop for food . Was about to pull into a car park and the bike stalled , fired her up again and had to give it a bit of gas to get her into the car park . It`s a K3 SV650s . The Idle speed was quite high so I adjusted that down a touch when I got to the car park as well . Once the bike had cooled down she seemed to be ok and the run home was fine . I popped into work to do an hours overtime and she was fine leaving work , I refuelled and as soon as I started her she stalled . Managed to get her going and gave it some gas and she seemed fine until I got to a set of lights near home , it seemed like she was running on one Cylinder and was popping and spitting . Got her home and let her cool down for a bit and then went outside to check her over . She fired up and went into fast Idle as usual and when she went to normal Idle I made sure it was set to 1300 rpm , the thing is now , when I raise the revs to about 2k to 3k she seems fine for a second then cuts , the lights dim a fraction , she picks up again and can randomly cut out of start chugging like a bastage and the Idle drops to around 1000 ...... any ideas ?