SV650.org - SV650 & Gladius 650 Forum - View Single Post - TPS Adjustment Step-by-Step Pictorial Guide

27-04-09, 08:12 PM

Just for information. If you are going to change the cheezy security torx fasteners with hex head cap screws, I found that the 16mm length was a better fit on my '06. The 20mm length were a bit long, and not knowing what the extra length would contact on the bottom screw, I cut some 20mm screws down to match the length of the original screws. I later found some 5mm, .80, 16mm screws that are a good replacement for the originals.

27-04-09, 08:12 PM	#84
AZ Pete Guest Posts: n/a	Re: TPS Mod Step-by-Step Pictorial Guide Just for information. If you are going to change the cheezy security torx fasteners with hex head cap screws, I found that the 16mm length was a better fit on my '06. The 20mm length were a bit long, and not knowing what the extra length would contact on the bottom screw, I cut some 20mm screws down to match the length of the original screws. I later found some 5mm, .80, 16mm screws that are a good replacement for the originals.