SV650.org - SV650 & Gladius 650 Forum - View Single Post

22-01-10, 12:32 AM

I need a small part of a yoke machined out and then an insert made to effectively move the steering pivot.

I have been looking for places who have ccm measuring equipment too but not much luck.

I'll do a little picture ad send it to you DavieSV.

22-01-10, 12:32 AM	#4
monkey Guest Posts: n/a	Re: Anyone know a good machining workshop? I need a small part of a yoke machined out and then an insert made to effectively move the steering pivot. I have been looking for places who have ccm measuring equipment too but not much luck. I'll do a little picture ad send it to you DavieSV. Last edited by monkey; 22-01-10 at 12:33 AM.