SV650.org - SV650 & Gladius 650 Forum - View Single Post

24-07-10, 05:23 PM

I can get it over the pins, its the xrings pushing back thats my problem, i cant see the groove for the clip to slide into. I think two spanners about 20mm and a clamp might work as a plate compressor. Ill have a go tomorrow, its so frustrating, im so close lol.

edit: no that wont work lol, slide need somewhere to slide the clip. ffs.

edit: The plate from the rivit link would hold it on by friction, but the clip link plate are designered to slip on easier.

24-07-10, 05:23 PM	#7
beabert Guest Posts: n/a	Re: Fitting a clip link on a xring chain. I can get it over the pins, its the xrings pushing back thats my problem, i cant see the groove for the clip to slide into. I think two spanners about 20mm and a clamp might work as a plate compressor. Ill have a go tomorrow, its so frustrating, im so close lol. edit: no that wont work lol, slide need somewhere to slide the clip. ffs. edit: The plate from the rivit link would hold it on by friction, but the clip link plate are designered to slip on easier. Last edited by beabert; 24-07-10 at 05:27 PM.