SV650.org - SV650 & Gladius 650 Forum - View Single Post

Shawthing · 30-05-11, 07:40 PM

Try switching hazard warning switch on and off a few times. This is only thing i can think could send power to all indicators and at the same time.
Contamination in switch could be letting current flow when it should not.

Though doesn't explain why one corner is not performing.

Asume you have wired both front indicators in parallel (on each side) and youve got polarity of each right. Unlike bulbs they have to be in right way round.
Sorry i dont know your

Electrically disconnect each indicator in turn and see if fault is related to an individual LED cluster ( fault goes away). If found temporarily swap in a now known working Cluster to see if you have a dodgy cluster., or use diode tester on a multimeter if you have one.

30-05-11, 07:40 PM	#4
Shawthing Member Join Date: May 2011 Location: Manchester Posts: 396	Re: K6 Electrical Question. Try switching hazard warning switch on and off a few times. This is only thing i can think could send power to all indicators and at the same time. Contamination in switch could be letting current flow when it should not. Though doesn't explain why one corner is not performing. Asume you have wired both front indicators in parallel (on each side) and youve got polarity of each right. Unlike bulbs they have to be in right way round. Sorry i dont know your Electrically disconnect each indicator in turn and see if fault is related to an individual LED cluster ( fault goes away). If found temporarily swap in a now known working Cluster to see if you have a dodgy cluster., or use diode tester on a multimeter if you have one. __________________ SK9 Sport Black Delkevic can. Non arbores caesa suum mittere nuntius, sed magnum numerum electrons uehementissime incommo.