Quote:
Originally Posted by andrewsmith
The Curvy's bar ends are straight into the material.
The S bolt is a countersunk item,
Your best bet is to use a 6mm bit and drill the head out, remove the weight and mole grip the remains of the bolt out.
|
Like the above said, drill the head off the countersunk bolt, its the easiest way. Its made of cheese so not hard to drill out. I used a 10mm drill, as this left no bolt head at all.
Then take the stub out with mole grips.
Don't try mole grips on the bar end itself, it'll just spin
I replaced mine with some lovely stainless steel countersunk allan bolts